Trackless Cantilever Gate Hardware for Sliding Gate Systems
Richmond’s cantilever gate hardware range is engineered for sliding gates that operate without a ground track. These systems are ideal for driveways, commercial sites, and yards where track maintenance, debris buildup, or surface variation makes traditional sliding gate tracks impractical. Built for industrial reliability, our cantilever components support smooth, low-maintenance operation on uneven or obstructed surfaces.
Cantilever Gate Components
- Cantilever Gate Rollers: High-load bearing rollers mounted to posts or walls to support the weight and motion of the gate frame.
- Cantilever Guide Channels: Welded or bolted under the gate frame, they engage with the roller system for stable, trackless movement.
- Mounting Brackets and End Stops: Secure installation and controlled gate travel with reliable positioning and clearance.
All components are designed for use with steel or aluminium gate frames and are suitable for both manual and motorised cantilever gates.
Applications and Use Cases
- Industrial driveways with gravel, dirt, or uneven concrete surfaces
- Commercial yards and service entries requiring low-maintenance access
- Sites with forklift or heavy vehicle traffic where ground tracks are unsuitable
- Driveways with water flow or debris that would obstruct track-based gates
Richmond cantilever hardware is commonly used where traditional sliding gate tracks cannot be installed or maintained efficiently.
Key Features
- Heavy-duty cantilever rollers with sealed bearings for long life
- Galvanised or zinc-coated steel components for outdoor durability
- Trackless sliding operation — no ground rail required
- Compatible with Richmond gate motors and automation kits
- Engineered for smooth, consistent motion under load
Frequently Asked Questions
What is a cantilever gate system?
A cantilever gate uses elevated rollers and a guide channel to support the gate, eliminating the need for a ground track — ideal for uneven or obstructed surfaces.
Can Richmond cantilever hardware be used with automated gates?
Yes. Our cantilever components are compatible with Richmond sliding gate motors and are commonly used in automated installations.
What materials are suitable for cantilever gate frames?
Most steel and aluminium gate frames can be fitted with cantilever guide channels and end stops. Check weight ratings to match the roller system.
What’s the minimum gate overhang required?
Cantilever gates require an overhang of approximately 40–50% beyond the opening width for proper support and balance. Contact Richmond for sizing guidance.